NOKIA ULTRASITE BTS HUB MANAGER DOWNLOAD FREE

This alarm is related to door fan Outdoor BTS only. The synthesizer in remote 1. Node synchronisation setup Backplane Instructions 1. If the alarm reactivates soon after the sector reset, consider it as a real RTC failure. The programs main features:

Uploader:	Arashirr
Date Added:	3 June 2017
File Size:	50.19 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	10076
Price:	Free* [*Free Regsitration Required]

The Severity column in the Alarms window indicates the level of the alarm for example critical, minor. Otherwise, replace the Transmission unit.

The transmitter output 1. Symbian SMS Manager 2.

The existing time limited license will allow use of the feature for 60 days. Recovery procedures Hbu the software licence Steps 1. Assess if the connection is faulty by viewing the condition bits of the protected cross-connections, nokiq the Condition Information frame. Check in the Cross-connections window that the right signal is connected to this interface at both ends of the hop.

The outdoor unit's interleaving settings are the same at both ends of the hop. Cancelling Automatically cancelled, when the problem has been corrected. The Abis cables are not properly Connect the Abis cables properly. Check Tx frequency and interleaving settings.

Nokia Ultrasite Bts Hub Manager

Start from the FXC units and proceed to the fan, and ultfasite replace the interface unit. Check the TSxx TX cable. The transmitter output power 1.

Create custom FM presets, save them on disk and send them to the phone anytime you want. Cancelling The alarm is cancelled when the VC path is taken into service at the far-end again. MS Instructions Check for open alarms at the far-end device and remove the cause of the alarms. Both ends of the hop are set to the same capacity.

Btts off this source did not succeed. No connection to power 1. Instructions Check the signal flow from the transmit direction of the alarming interface to the far-end. Cabinet fan is broken. The RF receiver frequency 1.

The node is running on the nookia clock as configured in the timing priority list, as none of the Rx or external clock sources defined in the timing priority list is valid.

Click here to sign up.

Nokia UltraSite BTS Hub Manager C - Nokia Corporation Software Informer.

Let us assume that the signal is acceptable, which indicates that the signal path up to that point is working. The modified alarm severity is visible in the local manager alarm window. The default settings are: If cabling is OK, replace the faulty TSxx.

The controller is out of 1.

DIU only MetroHub 6. Note The 16 MHz oscillator in the master unit is used as the internal clock of the node. Outdoor unit loop to interface is a far-end loop. The whole signal in the unit's interfaces bub looped back, synchronising it to the incoming signal.

Check the site mains power source and fuses.